Administrator Guide

• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ntp associations command shown in the
Example below.
Field Description
(none) One or more of the following symbols could be displayed:
• * means synchronized to this peer.
• # means almost synchronized to this peer.
• + means the peer was selected for possible
synchronization.
• - means the peer is a candidate for selection.
• ~ means the peer is statically configured.
remote Displays the remote IP address of the NTP peer.
ref clock Displays the IP address of the remote peer’s reference clock.
st Displays the peer’s stratum, that is, the number of hops
away from the external time source. A 16 in this column
means the NTP peer cannot reach the time source.
when Displays the last time the switch received an NTP packet.
poll Displays the polling interval (in seconds).
reach Displays the reachability to the peer (in octal bitstream).
delay Displays the time interval or delay for a packet to complete
a round-trip to the NTP time source (in milliseconds).
offset Displays the relative time of the NTP peer’s clock to the
switch clock (in milliseconds).
1558
System Time and Date