Administrator Guide
12
Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell Networking Operating System
(OS) on the Z-Series platform.
This chapter contains the following sections:
• Offline Diagnostic Commands
• Buffer Tuning Commands
• Hardware Commands
Offline Diagnostic Commands
The offline diagnostics test suite is useful for isolating faults and debugging hardware. While tests are
running, Dell Networking OS results are saved as a text file (TestReport-SU-X.txt) in the flash directory.
This
show file command is available only on master and standby.
Important Points to Remember
• Offline diagnostics can only be run when the unit is offline.
• You can only run offline diagnostics on a unit to which you are connected via the console. In other
words, you cannot run diagnostics on a unit to which you are connected to via a stacking link.
• Diagnostic results are printed to the screen. Dell Networking OS does not write them to memory.
• Diagnostics only test connectivity, not the entire data path.
diag stack-unit
Run offline diagnostics on a stack unit.
Z9000
Syntax
diag stack-unit number [alllevels | level0 | level1 | level2]
verbose testname
Parameters
number
Enter the stack-unit id.
Z9000 - 0 to 7.
Enter the stack-unit number. The range is from 0 to 7.
alllevels Enter the keyword alllevels to run the complete set of
offline diagnostic tests.
level0 Enter the keyword level0 to run Level 0 diagnostics. Level
0 diagnostics check for the presence of various components
496
Debugging and Diagnostics