Administrator Guide

default-router
Assign a default gateway to clients based on the address pool.
Z9000
Syntax
default-router address [address2...address8]
Parameters
address Enter a list of routers that may be the default gateway for
clients on the subnet. You may specify up to eight routers.
List them in order of preference.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
disable
Disable the DHCP server.
Z9000
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use
the no disable command.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Dynamic Host Configuration Protocol (DHCP)
517