Administrator Guide

gvrp enable
Enable GVRP on physical interfaces and LAGs.
Z9000
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION-INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related
Commands
disable — globally disables GVRP.
gvrp registration
Configure the GVRP register type.
Z9000
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed Enter the keyword fixed then the VLAN range in a comma-
separated VLAN ID set.
normal Enter the keyword normal then the VLAN range in a
comma-separated VLAN ID set. This setting is the default.
forbidden Enter the keyword forbidden then the VLAN range in a
comma-separated VLAN ID set.
578
GARP VLAN Registration (GVRP)