Administrator Guide

tdr-cable-test
Test the condition of copper cables on 100/1000 Base-T modules.
Z9000
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword GigabitEthernet then the slot/port
information for the 100/1000 Ethernet interface.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
Usage
Information
The interface must be enabled to run the test or an error message is generated:
Dell#tdr-cable-test gigabitethernet 5/2
%Error: Interface is disabled GI 5/2
The S-Series does not generate log messages is generated when the link flaps
down/up during TDR tests.
Related
Commands
show tdr — displays the results of the TDR test.
698
Interfaces