Administrator Guide

enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may
need to enter a password.
Z9000
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of Dell
Networking OS. The range is from 0 to 15.
Defaults 15
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added support for roles on the Z9000, S6000, S4820T,
S4810, MXL
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can
access configuration commands. To protect against unauthorized access, use the
enable password command to configure a password for the enable command
at a specific privilege level. If no privilege level is specified, the default is privilege
level
15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do
not need to enter an enable password.
96
Control and Monitoring