Administrator Guide

ip multicast-msdp
Enable MSDP.
Z9000
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
show ip msdp
Display the MSDP peer status, SA cache, or peer summary.
Z9000
Syntax
show ip msdp {peer peer address | sa-cache | summary}
Parameters
peer peer
address
Enter the keyword peer then the peer address in a dotted
decimal format (A.B.C.D.).
sa-cache Enter the keywords sa-cache to display the Source-Active
cache.
summary Enter the keyword summary to display an MSDP peer
summary.
Defaults Not configured.
Multicast Source Discovery Protocol (MSDP)
995