Reference Guide

Bidirectional Forwarding Detection (BFD) | 129
Figure 7-8. Changing Session Parameters for Physical Ports
Disabling and re-enabling BFD
BFD is enabled on all interfaces by default, though sessions are not created unless explicitly configured. If
BFD is disabled, all of the sessions on that interface are placed in an Administratively Down state
(Message 2), and the remote systems are notified of the session state change (Message 3).
To disable BFD on an interface:
Step Task Command Syntax Command Mode
1 Disable BFD on an interface. no bfd enable INTERFACE
Message 2 Disabling BFD on a Local Interface
R1(conf-if-gi-4/24)#01:00:52: %RPM0-P:RP2 %BFDMGR-1-BFD_STATE_CHANGE: Changed session state to Ad Dn for
neighbor 2.2.2.2 on interface Gi 4/24 (diag: 0)
Message 3 Remote System State Change due to Local State Admin Down
R2>01:32:53: %RPM0-P:RP2 %BFDMGR-1-BFD_STATE_CHANGE: Changed session state to Down for neighbor 2.2.2.1
on interface Gi 2/1 (diag: 7)
R1(conf-if-gi-4/24)#bfd interval 100 min_rx 100 multiplier 4 role passive
R1(conf-if-gi-4/24)#do show bfd neighbors detail
Session Discriminator: 1
Neighbor Discriminator: 1
Local Addr: 2.2.2.1
Local MAC Addr: 00:01:e8:09:c3:e5
Remote Addr: 2.2.2.2
Remote MAC Addr: 00:01:e8:06:95:a2
Int: GigabitEthernet 4/24
State: Up
Configured parameters:
TX: 100ms, RX: 100ms, Multiplier: 4
Neighbor parameters:
TX: 100ms, RX: 100ms, Multiplier: 3
Actual parameters:
TX: 100ms, RX: 100ms, Multiplier: 4
Role: Passive
Delete session on Down: False
Client Registered: CLI
Uptime: 00:09:06
Statistics:
Number of packets received from neighbor: 4092
Number of packets sent to neighbor: 4093
Number of state changes: 1
Number of messages from IFA about port state change: 0
Number of messages communicated b/w Manager and Agent: 7
Parameter