Reference Guide

264 | Content Addressable Memory (CAM)
www.dell.com | support.dell.com
Reserved : 8K entries : 8K entries
FIB : 0 entries : 0 entries
ACL : 0 entries : 0 entries
Flow : 0 entries : 0 entries
EgACL : 0 entries : 0 entries
MicroCode Name : Default : Default
--More--
View a brief output of the command show cam-profile using the summary option.
The command
show running-config cam-profile shows the current profile and microcode as shown in the
following example.
FTOS#show running-config cam-profile
!
cam-profile default microcode default
FTOS#
View CAM-ACL settings
The show cam-acl command is supported on platforms c s
View the current cam-acl settings for the C-Series, S-Series and systems chassis and each
component using the command
show cam-acl, as shown in as shown in the following examples.
The default values for the
show cam-acl command for C-Series and S-Series are:
FTOS# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
-- Line card 0 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
Note: If you select the CAM profile from CONFIGURATION mode, the output of this command does not
reflect any changes until you save the running-configuration and reload the chassis.