Reference Guide

346 | Force10 Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
Set FRRP Timers
3 interface primary int
slot/port secondary int
slot/port control-vlan
vlan id
CONFIG-FRRP Assign the Primary and Secondary ports, and the
Control VLAN for the ports on the ring.
Interface:
• For a 10/100/1000 Ethernet interface, enter the
keyword keyword GigabitEthernet followed by
the slot/port information.
• For a Gigabit Ethernet interface, enter the
keyword GigabitEthernet followed by the slot/
port information
• For a SONET interface, enter the keyword sonet
followed by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword
TenGigabitEthernet followed by the
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Slot/Port: Slot and Port ID for the interface.
VLAN ID: Identification number of the Control
VLAN
4 mode transit CONFIG-FRRP Configure a Transit node
5 member-vlan vlan-id
{range}
CONFIG-FRRP Identify the Member VLANs for this FRRP group
VLAN-ID, Range: VLAN IDs for the ring’s Member
VLANs.
6
no disable
CONFIG-FRRP Enable this FRRP group on this switch.
Step Command Syntax Command Mode Purpose
1 timer
{hello-interval|dead-interval}
milliseconds
CONFIG-FRRP Enter the desired intervals for Hello-Interval or
Dead-Interval times.
Hello-Interval: 50-2000, in increments of 50
(default is 500)
Dead-Interval: 50-6000, in increments of 50
(default is 1500)
The Dead-Interval time should be set at 3x the Hello-Interval.
Step Command Syntax Command Mode Purpose