Reference Guide

Interfaces | 377
To configure a Management interface, use the following command in the CONFIGUR ATION mode:
You can configure two global IPv6 addresses on the S4810 and Z9000 systems in EXEC Privilege mode.
To view the addresses, use the
show interface managementethernet command as shown below. If you
try to configure a third IPv6 address, an error message displays. If auto-configuration is enabled, all IPv6
addresses on that management interface are auto-configured. The first IPv6 address that is configured on
the management interface will be the primary address. If deleted, it must be re-added; the secondary
address is not promoted.
The following rules apply to having two IPv6 addresses on a management interface:
IPv6 addresses on a single management interface cannot be in the same subnet.
IPv6 secondary addresses on management interfaces:
across a platform must be in the same subnet.
should not match the virtual IP address and should not be in the same subnet as the virtual IP.
Figure 19-8. Viewing Two Global IPv6 Addresses on the S4810 and Z9000
To view the Primary RPM Management port, use the show interface managementethernet command in
the EXEC Privilege mode. If there are two RPMs, you cannot view information on that interface.
Command Syntax Command Mode Purpose
interface managementethernet
interface CONFIGURATION Enter the slot and the port (0).
ON the E-Series and C-Series, dual RPMs can
be in use.
Slot range:
C-Series, E-Series: 0-1
S4810, Z9000: 0
FTOS#show interfaces managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:01:e8:a0:bf:f3
Current address is 00:01:e8:a0:bf:f3
Pluggable media not present
Interface index is 302006472
Internet address is 10.16.130.5/16
Link local IPv6 address: fe80::201:e8ff:fea0:bff3/64
Global IPv6 address: 1::1/
Global IPv6 address: 2::1/64
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:06:14
Queueing strategy: fifo
Input 791 packets, 62913 bytes, 775 multicast
Received 0 errors, 0 discarded
Output 21 packets, 3300 bytes, 20 multicast
Output 0 errors, 0 invalid protocol
Time since last interface status change: 00:06:03