Reference Guide

980 | Index
www.dell.com | support.dell.com
member of VLANs 906
Port channels
benefits
381
defaults 374
port channels
adding physical interface 384, 385
assigning IP address 389
commands allowed on individual interfaces 384
configuring 384
containing 100/1000 and GE interfaces 382
IP routing 389
placing in Layer 2 mode 384
reassigning interfaces 387
port cost 772, 879
port mirror 687
Port Monitoring Commands
Important Points to Remember 687
port priority 772, 879
port types (private VLAN) 696
port-based VLANs 905
assigning IP address 910
benefits 905
creating VLAN 906
definition 905
deleting VLAN 907
enabling tagging 908
interface requirements 905
IP routing 905
number supported 905
remove interface 909
remove tagged interface 908
tag frames 908
tagged interface
member of multiple VLANs 908
Portfast 773, 880
PPP 373
Prefix list. See IP Prefix list.
primary VLAN 696
Private VLAN (PVLAN) 695
private-vlan mapping secondary-vlan command 697
Privilege Level 794
privilege levels
and CLI commands 786
definition 785
number of levels available 785
privilege level 0 definition 786
privilege level 1 definition 786
privilege level 15 definition 786
promiscuous port 696
Protocol Data Units. See PDU.
Proxy ARP
default 426
Q
QoS
dot1p queue numbers
720
dot1p-priority values 720
purpose of input policies 728
rate limit outgoing traffic 723
QoS (Quality of Service) chapter 717
QSFP port splitting 399
Quality of Service (QoS) chapter 717
R
RADIUS
changing an optional parameter
795
configuration requirements 792
configuring global communication parameter 796
debugging RADIUS transactions 797, 799
definition 792
deleting a server host 796
specifying a server host 795, 800
viewing RADIUS configuration 796
RADIUS authentication 785
RADIUS Authentication and Authorization 792
radius-server host command 784
rate-interval command 412
redistribute
ROUTER ISIS 199, 503, 504
RFC 1058 743
RFC 1493 874
RFC 1858 801
RFC 2138 792
RFC 2338 948
RFC 2453 743
RFC 3128 801
RFC 791 417, 418
RFC 959 58
RFC Compliance 964
RIP
adding routes 748
auto summarization default 744
changing RIP version 748
configuring interfaces to run RIP 746
debugging RIP 752
default values 744
default version 745
disabling RIP 746
ECMP paths supported 744
enabling RIP 745
route information 747