Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000
611612613614615616617618619620
Dell(conf-mon-sess-0)#show c
!
monitor session 0
source TenGigabitEthernet 0/0 destination TenGigabitEthernet 0/1 direction rx
Dell(conf-mon-sess-0)#
Dell(conf-mon-sess-0)#do show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ------------ --- ---- --------- --------
0 Te 0/0 Te 0/1 rx Port N/A N/A
Dell(conf)#monitor session 0
Dell(conf-mon-sess-0)#source po 10 dest ten 0/1 dir rx
Dell(conf-mon-sess-0)#do show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
0 Te 0/0 Te 0/1 rx Port N/A N/A
0 Po 10 Te 0/1 rx Port N/A N/A
Dell(conf)#monitor session 1
Dell(conf-mon-sess-1)#source vl 40 dest ten 0/2 dir rx
Dell(conf-mon-sess-1)#flow-based enable
Dell(conf-mon-sess-1)#exit
Dell(conf)#do show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
0 Te 0/0 Te 0/1 rx Port N/A N/A
0 Po 10 Te 0/1 rx Port N/A N/A
1 Vl 40 Te 0/2 rx Flow N/A N/A
Note: Source as VLAN is achieved via Flow based mirroring. Please refer section Enabling Flow-Based
Monitoring.
In the following example, the host and server are exchanging traffic which passes through the uplink
interface 1/1. Port 1/1 is the monitored port and port 1/42 is the destination port, which is configured to
only monitor traffic received on tengigabitethernet 1/1 (host-originated traffic).
Port Monitoring
611