Reference Guide

ip telnet server vrf
Configures the TELNET server on either a specific VRF or a management VRF.
Z9000
Syntax ip telnet server vrf {management | vrf-name}
To undo the TELNET server configuration, use the no ip telnet server [vrf
vrf-name] command.
Parameters
vrf
management
Enter the keyword vrf followed by the keyword
management to specify a management VRF that is used by
the TELNET server.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TELNET server.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
You can enable the TELNET server on either a management VRF or a user defined
VRF but not both. If you do not specify a VRF, then the TELNET server is enabled on
the default VRF.
Example
FTOS(conf)#ip telnet server vrf vrf1
FTOS(conf)#no ip telnet server vrf
FTOS(conf)#ip telnet server vrf management
FTOS(conf)#no ip telnet server vrf
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Z9000
Syntax
ip telnet source-interface interface
To return to the default setting, use the no ip telnet source-interface
[
interface] command.
110
Control and Monitoring