Reference Guide

To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name]
command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TFTP client.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to make the TFTP clients VRF aware. The VRF name that you
specify is used by the TFTP client to reach the TFTP server. If no VRF is specified,
then the default VRF is used.
Related
Commands
ftp-server topdir — sets the directory to be used for incoming FTP connections to
the E-Series.
ftp-server username — sets a username and password for incoming FTP
connections to the E-Series.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Z9000
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal
connection.
console 0 Enter the keyword console 0 to configure the console
port. The console option for the S-Series is
<0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to
configure a virtual terminal line for Telnet sessions. The
system supports 10 Telnet sessions.
114
Control and Monitoring