Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000

1471

E-Series legacy

command

Usage

Information

The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the

name of a sub-tree or a MIB. The following Example configures a view named

rview that allows access to all objects under 1.3.6.1.

Example

Dell# conf

Dell#(conf) snmp-server view rview 1.3.6.1 included

Commands

show running-config snmp — displays the SNMP running configuration.

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.

Z-Series

Syntax

snmp trap link-status

To disable sending link trap messages, use the no snmp trap link-status

command.

Defaults Enabled.

Command

Modes

INTERFACE

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0 Introduced on the S6000.

Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Version

8.3.19.0

Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.