Reference Guide

E-Series legacy
command
Related
Commands
logging — enables logging to a Syslog server.
logging on — enables logging.
logging history
Specify which messages are logged to the history table of the switch and the SNMP network
management station (if configured).
Z-Series
Syntax
logging history level
To return to the default values, use the no logging history command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
equivalent words: emergencies, alerts, critical,
errors, warnings, notifications, informational, or
debugging. The default is 4 or warnings.
Defaults warnings or 4
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you configure the snmp-server trap-source command, the system
messages logged to the history table are also sent to the SNMP network
management station.
Simple Network Management Protocol (SNMP) and Syslog
1485