Reference Guide

storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only)
network only.
Z-Series
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_se
cond in
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-series and S-Series.
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Z-Series
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control
unknown-unicast [packets_per_second in] command.
Parameters
packets_per_se
cond in
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
1522
Storm Control