Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000

1631

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

pre-Version

6.2.1.1

Introduced on the E-Series.

priority

Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER

election process.

Z-Series

Syntax

priority priority

To return to the default value, use the no priority command.

Parameters

priority Enter a number as the priority. Enter 255 only if the router’s

virtual address is the same as the interface’s primary IP

address (that is, the router is the OWNER). The range is from

1 to 255. The default is 100.

Defaults 100

Command

Modes

VRRP

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0 Introduced on the S6000.

Version

8.3.16.0

Introduced on the S4820T.