Reference Guide

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced support for telnetting to the VRRP group IP
address assigned using this command.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
A system message appears after you enter or delete the virtual-address
command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with the same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Z-Series
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP
initialization after an interface becomes operational. The
range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
1638
Virtual Router Redundancy Protocol (VRRP)