Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
You can assign one ACL (standard or extended) to an interface.
Related
Commands
mac access-list standard — configures a standard MAC ACL.
mac access-list extended — configures an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface,
and the count of matches/mismatches against each ACL entry displayed.
Z9000
Syntax
show mac access-lists [access-list-name] [interface interface]
[in | out]
Parameters
access-list-
name
Enter the name of a configured MAC ACL, up to 140
characters.
interface
interface
Enter the keyword interface then the one of the following
keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword port-
channel and then enter a number. The C-Series and S-
Series range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and then enter the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE and then enter the slot/port information.
• For a VLAN interface, enter the keyword VLAN followed
by the vlan id.
in | out Identify whether ACL is applied on ingress or egress side.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Access Control Lists (ACL)
217