Reference Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
permit
To forward packets from a specific source MAC address, configure a filter.
Z9000
Syntax
permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit {any | mac-source-address mac-source-
address-mask
} command.
222
Access Control Lists (ACL)