Reference Guide

NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
permit — configures a MAC address filter to pass packets.
seq — configures a MAC address filter with a specified sequence number.
mac access-list extended
Name a new or existing extended MAC access control list (extended MAC ACL).
Z9000
Syntax
mac access-list extended access-list-name [cpu-qos
To delete a MAC access list, use the no mac access-list extended access-
list-name
command.
Parameters
access-list-
name
Enter a text string as the MAC access list name, up to 140
characters.
cpu-qos Enter the keywords cpu-qos to assign this ACL to control
plane traffic only (CoPP).
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0
Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
228
Access Control Lists (ACL)