Reference Guide

1 NO-ADVERTISE
1 200:1 1000:1 3000:1
show ip bgp peer-group
Allows you to view information on the BGP peers in a peer group.
Z-Series
Syntax
show ip bgp [ipv4 unicast] peer-group [peer-group-name [detail
| summary]]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
peer-group-
name
(OPTIONAL) Enter the name of a peer group to view
information about that peer group only.
detail (OPTIONAL) Enter the keyword detail to view detailed
status information of the peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is the
same as that found in the
show ip bgp summary
command.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp peer-group command shown in the
following example.
450
Border Gateway Protocol