Reference Guide

IpMacAcl : 0
VmanQos : 0
VmanDualQos: 0
Ipv4pbr : 0
Dell#
test cam-usage
Verify that enough CAM space is available for the IPv6 ACLs you have created.
Z9000
Syntax
test cam-usage service-policy input input policy name linecard
{number | all}
Parameters
policy-map
name
Enter the name of the policy-map to verify. Maximum is 32
characters.
number Enter all to get information for all the linecards/stack-units
or enter the linecard/ stack-unit number to get information
for a specific card. The range is : 0-11 for S4810; 0-7 for all
other S-Series
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced.
Usage
Information
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when
verifying QoS optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a
policy on a single (or the first of several) interfaces. It is most useful when a policy
is applied across multiple interfaces; it can reduce the impact to CAM usage across
subsequent interfaces.
486
Content Addressable Memory (CAM)