Reference Guide
show ip cam linecard
View CAM entries for a port pipe on a line card.
Syntax
show ip cam linecard number port-set pipe-number [ip-address
mask [longer-prefixes] | index index-number | summary | vrf vrf
instance]
Parameters
number Enter the number of the line card.
pipe-number Enter the number of the line card’s port-pipe. The range is
from 0 to 1.
ip-address
mask [longer-
prefix]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. Enter the keyword longer-
prefixes to view routes with a common prefix.
index index-
number
(OPTIONAL) Enter the keyword index then the CAM index
number. The range depends on CAM size.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number of routes that can
be entered into the CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the
VRF instance name to show CAM information as it applies to
that VRF instance.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.2 Introduced on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
IPv4 Routing
767