Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip cam command shown in the following
example.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this
entry is forwarded to the CP or RP2, depending on Egress
port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the
entry to determine the interface. For example, in the entry
17cl CP, the CP is the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
Example
Dell#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-
prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - ------ --------------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00 3f01 CP
Dell#
Usage
Information
The following describes the show ip cam ecmp-group command shown in the
following example.
IPv4 Routing
771