Reference Guide

Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
show lacp — displays the LACP configuration.
debug lacp
Debug LACP (configuration, events, and so on).
Z9000
Syntax
debug lacp [config | events | pdu [interface-type [in | out]]]
To disable LACP debugging, use the no [config | events | pdu
[interface-type [in | out]]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP
event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information.
interface-type
in | out
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
900
Link Aggregation Control Protocol (LACP)