Reference Guide

To disable debugging, use the no debug lldp interface {interface |
all}{events} {packet {brief | detail} {tx | rx | both}}
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
NOTE: The FastEthernet option is not supported on
the S-Series.
all (OPTIONAL) Enter the keyword all to display information
on all interfaces.
events (OPTIONAL) Enter the keyword events to display major
events such as timer events.
packet (OPTIONAL) Enter the keyword packet to display
information regarding packets coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet
information.
detail (OPTIONAL) Enter the keyword detail to display detailed
packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only
packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only
packet information.
both (OPTIONAL) Enter the keyword both to display both receive
and transmit packet information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Link Layer Discovery Protocol (LLDP)
961