Reference Guide

Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Before LLDP can be configured on an interface, it must be enabled globally from
CONFIGURATION mode. This command places you in LLDP mode on the
interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Z9000
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV
information, remote management IP addresses, timers, and
LLDP tx and rx counters.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1.
(0.0)
Modified output of detail parameter to display remote
management IP addresses.
Link Layer Discovery Protocol (LLDP)
967