Reference Guide

Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Deprecated command for S4820T. Replaced by the enable
optic-info-update interval command to update
information on temperature and power monitoring in the
SNMP MIB.
Version 8.3.11.4 Deprecated command for Z9000. Replaced by the enable
optic-info-update interval
command to update
information on temperature and power monitoring in the
SNMP MIB.
Version
8.3.10.0
Deprecated command for the S4810 only. Replaced by the
enable optic-info-update interval command to
update information on temperature and power monitoring in
the SNMP MIB.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
The chassis MIB contains the entry chSysXfpRecvPower in the chSysPortTable
table. Periodically, IFA polls the XFP power for each of the ports and sends the
values to IFM where it is cached.
To enable polling and to configure the polling frequency, use this command.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or ROUTER
OSPF modes).
Z9000
Syntax
end
Command
Modes
• CONFIGURATION
• SPANNING TREE
• MULTIPLE SPANNING TREE
• LINE
Control and Monitoring
97