Addendum

00:00:40: %S6000:0 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted in slot 0
port 3
On Optic Removal:
00:04:41: %S6000:0 %IFAGT-5-REMOVE_OPTICS_QSFP: Optics QSFP inserted in slot 0
port 0
00:04:41: %S6000:0 %IFAGT-5-REMOVE_OPTICS_QSFP: Optics QSFP inserted in slot 0
port 1
00:04:41: %S6000:0 %IFAGT-5-REMOVE_OPTICS_QSFP: Optics QSFP inserted in slot 0
port 2
00:04:41: %S6000:0 %IFAGT-5-REMOVE_OPTICS_QSFP: Optics QSFP inserted in slot 0
port 3
The following is the sample output of the show interface media command when the management optic
is inserted:
Slot Port Type Media Serial Number
F10Qualified
------------------------------------------------------------------------------
0 0 QSFP 40GBASE-XXX QB520116 Yes
0 1 QSFP 40GBASE-XXX QB520116 Yes
0 2 QSFP 40GBASE-XXX QB520116 Yes
0 3 QSFP 40GBASE-XXX QB520116 Yes
The following is the sample output of the show interface transceiver command when the management
optic is inserted:
QSFP 0 Serial ID Base Fields
QSFP 0 Id = 0x0d
QSFP 0 Ext Id = 0x00
QSFP 0 Connector = 0x0c
QSFP 0 Transceiver Code = 0x04 0x00 0x00 0x00 0x00 0x00 0x00 0x00
QSFP 0 Encoding = 0x05
QSFP 0 Length(SFM) Km = 0x00
QSFP 0 Length(OM3) 2m = 0x32
QSFP 0 Length(OM2) 1m = 0x00
QSFP 0 Length(OM1) 1m = 0x00
QSFP 0 Length(Copper) 1m = 0x00
QSFP 0 Vendor Rev = 0
Based on detecting the management optic type, the default settings are set in both the MAC and PHY
elements.
On the MAC:
1. Set speed as 1G.
2. Duplex as Full
3. Interface type as SGMII
4. Autoneg off.
On the PHY:
1. Auto neg ON.
2. Full-duplex and half-duplex on.
3. Advertise 10M,100M,1G
4. Out of reset.
Management Port Media Converter
211