Addendum

ip igmp snooping last-member-query-interval
The last member query interval is the maximum response time inserted into Group-Specific queries sent
in response to Group-Leave messages.
Z9000 S4810 S4820TS6000
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-
query-interval
command.
Parameters
milliseconds Enter the interval in milliseconds. The range is from 100 to
65535. The default is 1000 milliseconds.
Defaults 1000 milliseconds
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This last-member-query-interval is also the interval between successive Group-
Specific Query messages. To change the last-member-query interval, use this
command.
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
Z9000 S4810 S4820TS6000
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping
mrouter interface interface command.
Internet Group Management Protocol (IGMP)
359