Addendum

Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mode
To receive or transmit, set LLDP.
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
show lldp neighbors — displays the LLDP neighbors.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
Defaults 4 x hello
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
380
Link Layer Discovery Protocol (LLDP)