Addendum

service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
Z9000 S4810 S4820T
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters
dot1p0 value ...
dot1p7 value
Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p Priority: 0 1 2 3 4 5 6 7
• CoS Queue: 0 0 0 1 2 3 3 3
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping
on the switch.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
Syntax
service-class bandwidth-percentage queue0 number queue1 number
queue2 number queue3 number
392
Quality of Service (QoS)