Addendum

mode, enter the stop bmp command. The startup configuration is then loaded
from the local flash on the switch.
To toggle between Normal and BMP Auto Configuration modes, use the reload-
type
command in BMP 3.0. Reload settings for Auto Configuration mode that you
configure are stored in memory and retained for future reboots and BMP software
upgrades. To reload the switch in the last configured mode: Normal reload or BMP
mode, you can enter the reload command at any time.
Upgrade any configuration changes that have changed the NVRAM content by
performing a reload on the chassis.
While BMP is on, the Dell Networking OS Command Line Reference Guide prompt
changes to “Dell-BMP”.
Related
Commands
• show reload-type — displays the current reload mode (BMP or Normal mode).
• stop jumpstart — Stops the Jumpstart (BMP) process to prevent a loop if the
DHCP server is not found
reload-type
409