Addendum

Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.1(0.0) Added support for copy-config and ecmp traps.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for VRRP traps.
Version 7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-
Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
FTOS supports up to 16 SNMP trap receivers.
For the cam-utilization notification option, the system generates syslogs and
SNMP traps when the L3 host table or route table utilization goes above the
threshold.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server host
Configure the recipient of an SNMP trap operation.
Z-Series S4810 S4820T
Syntax
snmp-server host ip-address | ipv6-address [traps | informs]
[version 1 | 2c | 3] [auth | no auth | priv] [community-string]
[udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address
[traps | informs] [version 1 | 2c | 3] [auth | noauth | priv]
[community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in
the x:x:x:x::x format.
Simple Network Management Protocol (SNMP) and Syslog
413