Addendum

Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Usage
Information
The dcb-policy output stack-unit all command overwrites any previous
dcb-policy output stack-unit stack-unit-id configurations. Similarly, a
dcb-policy output stack-unit stack-unit-id command overwrites any
previous dcb-policy output stack-unit all configuration.
You can apply a DCB output policy with ETS configuration to all stacked ports in a
switch stack or an individual stacked switch. You can apply different DCB output
policies to different stack units.
Related
Commands
dcb-policy input stack-unit stack-ports all — applies the specified DCB input
policy.
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is
32 characters.
Defaults none
Command
Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Related
Commands
• dcb-input — creates a DCB PFC input policy.
• dcb-policy input — applies the output policy.
• dcb-output — creates a DCBETS output policy.
• dcb-policy output — applies the output policy.
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
Data Center Bridging (DCB) for FC Flex IO Modules
505