Addendum

• bandwidth-percentage — bandwidth percentage allocated to priority traffic in
port queues.
set-pgid
Configure the priority-group identifier.
Syntax
set-pgid value
To remove the priority group, use the no set-pgid command.
Parameters
value Enter the priority group identification. The range is from 0 to
7.
Defaults none
Command
Modes
PRIORITY-GROUP
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch.
Related
Commands
• priority-group qos-policy — creates an ETS priority group.
• priority-list — configures the 802.1p priorities.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type slot/port ets {summary | detail}
Parameters
port-type slot/
port ets
Enter the port-type slot and port ETS information.
{summary |
detail}
Enter the keyword summary for a summary list of results or
enter the keyword
detail for a full list of results.
Command
Modes
CONFIGURATION
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch.
Usage
Information
To clear ETS TLV counters, use the clear ets counters interface port-
type slot/port
command.
The following describes the show interface summary command shown in the
following example.
Data Center Bridging (DCB) for FC Flex IO Modules
511