Addendum

Example (Single
Range)
FTOS(conf)#interface vlan 10
FTOS(conf-if-vl-3)#
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
keepalive
In an FCoE map, enable the monitoring of FIP keepalive messages (if it is disabled).
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
keepalive
Parameters None
Defaults FIP keepalive monitoring is enabled on Ethernet and Fibre Channel interfaces.
Command
Modes
FCOE MAP
Command
History
Version 9.3.0.0 Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
FIP keepalive (FKA) messaging is used to detect if other FCoE devices are reachable.
To remove FIP keepalive monitoring from an FCoE map, enter the no keepalive
command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
priority-group bandwidth pfc
Configure the ETS bandwidth allocation and PFC mode used to manage port traffic in an 802.1p priority
group.
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
priority-group group-num {bandwidth percentage| strict-
priority} pfc {on | off}
Parameters
priority-group
group-num
Enter the keyword priority-group followed by the
number of an 802.1p priority group. Use the priority-
pgid
command to create the priority groups in a DCB map.
NPIV Proxy Gateway for FC Flex IO Modules
579