Addendum

interval
minutes
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
You can enter an interval in the range of 1-10 minutes.
Defaults By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is 5 minutes.
Command
Modes
ACCESS-LIST
Command
History
Version 9.3.0.0 Added support for logging of ACLs on the S4810, S4820T,
Z9000, M I/O Aggregator and MXL 10/40GbE Switch IO
Module platforms.
Usage
Information
When the configured maximum threshold is exceeded, generation of logs is
stopped. When the interval at which ACL logs are configured to be recorded
expires, the subsequent, fresh interval timer is started and the packet count for that
new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is reenabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is
reenabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, standard and extended IPv6 ACLs, and standard
and extended MAC ACLs. You can configure ACL logging only on ACLs that are
applied to ingress interfaces; you cannot enable logging for ACLs that are
associated with egress interfaces.
Related
Commands
deny – configures a filter to drop packets.
permit – configures a filter to forward packets.
permit udp (for IPv6 ACLs)
Configure a filter to pass UDP packets meeting the filter criteria.
NOTE: Only the options that have been newly introduced are described here. For a complete
description on all of the keywords and variables that are available with this command, refer the
respective Command Reference Guide of the applicable platform of the Release 9.2.0.0
documentation set.
Syntax
permit udp {source address mask | any | host ipv6-address}
[operator port [port]] {destination address | any | host ipv6-
address} [operator port [port]] [count [byte]] [log [interval
minutes] [threshold-in-msgs [count]]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit udp {source address mask | any | host ipv6-
address} {destination address | any | host ipv6-address}
command.
72
Access Control Lists