Command Line Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
If this command is not configured, cost is based on the auto-cost command.
When you configure OSPF over multiple vendors, to ensure that all routers use the
same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly.
Related
Commands
auto-cost — controls how the OSPF interface cost is calculated.
ip ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the interval elapses, the
neighboring routers declare the router dead.
Z9000
Syntax
ip ospf dead-interval seconds
To return to the default values, use the no ip ospf dead-interval command.
Parameters
seconds Enter the number of seconds for the interval. The range is
from 1 to 65535. The default is 40 seconds.
Defaults 40 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
1050
Open Shortest Path First (OSPFv2 and OSPFv3)