Command Line Reference Guide

line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Z9000
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal
connection.
console 0 Enter the keyword console 0 to configure the console
port. The console option for the S-Series is
<0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to
configure a virtual terminal line for Telnet sessions. The
system supports 10 Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual
terminal line to configure. You can configure multiple lines at
one time.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
Related
Commands
access-class — restricts the incoming connections to a particular IP address in an
IP access control list (ACL).
116
Control and Monitoring