Command Line Reference Guide

Usage
Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes
the requests from the interfaces that belong to the specified VRF. If no VRF is
specified, then the default VRF is used.
Related
Commands
show snmp user — displays the information configured on each SNMP user name.
snmp-server view
Configure an SNMPv3 view.
Z-Series
Syntax
snmp-server view view-name oid-tree {included | excluded}
To remove an SNMPv3 view, use the no snmp-server view view-name oid-
tree {included | excluded} command.
Parameters
view-name Enter the name of the view (not to exceed 20 characters).
oid-tree Enter the OID sub tree for the view (not to exceed 20
characters).
included (OPTIONAL) Enter the keyword included to include the MIB
family in the view.
excluded (OPTIONAL) Enter the keyword excluded to exclude the
MIB family in the view.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
1476
Simple Network Management Protocol (SNMP) and Syslog