Command Line Reference Guide

Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging monitor — sets the logging monitor parameters.
terminal monitor — sends system messages to the terminal/monitor.
default logging trap
Return to the default settings for logging messages to the Syslog servers.
Z-Series
Syntax
default logging trap
Defaults level = 6 or informational
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging trap — limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Z-Series
Syntax
logging {ip-address | ipv6-address | hostname} {{udp {port}} |
{tcp {port}}
Simple Network Management Protocol (SNMP) and Syslog
1481