Command Line Reference Guide

E-Series legacy
command
Usage
Information
When the number of messages reach the limit you set with the logging history
size command, older messages are deleted as newer ones are added to the table.
Related
Commands
show logging — displays information logged to the history buffer.
logging monitor
Specify which messages are logged to Telnet applications.
Z-Series
Syntax
logging monitor [level]
To disable logging to terminal connections, use the no logging monitor
command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
parameters:
emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Defaults 7 or debugging
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Simple Network Management Protocol (SNMP) and Syslog
1489