Command Line Reference Guide

debug vrrp
Allows you to enable debugging of VRRP.
Z-Series
Syntax
debug vrrp interface [vrrp-id] {all | bfd | database |
interface | ipv6 | packets | state | timer}
To disable debugging, use the no debug vrrp interface [vrrp-id] {all |
bfd | database | interface | ipv6 | packets | state | timer}
command.
Parameters
interface Enter the following keywords and slot/port or number
information
• For Port Channel interface types, enter the keywords
port-channel then the number. The range is from 1 to
128.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
bfd Enter the keyword bfd to enable debugging of VRRP BFD
interactions.
database Enter the keyword database to enable debugging of
configuration changes.
interface Enter the keyword interface to enable debugging of
interface state changes..
ipv6 Enter the keyword ipv6 to enable debugging for IPv6.
packets Enter the keyword packets to enable debugging of VRRP
control packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP
timer.
1626
Virtual Router Redundancy Protocol (VRRP)