Command Line Reference Guide

Dell(conf-if-te-0/0-vrid-100)#version 3
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The
range is from 1 to 255.
vrf instance (OPTIONAL) E-Series only: Enter the name of a VRF instance
(32 characters maximum) to clear the counters of all IPv6
VRRP groups in the specified VRF.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
1640
Virtual Router Redundancy Protocol (VRRP)