Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To configure a COMMUNITY attribute, use the set community command in
ROUTE-MAP mode.
In order that settings corresponding to the neighbor send-community
command take effect, you must execute the clear ip bgp command
immediately after you execute the neighbor send-community command.
neighbor shutdown
Disable a BGP neighbor or peer group.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address |
peer-group-name}no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
408
Border Gateway Protocol