Command Line Reference Guide

11
Control Plane Policing (CoPP)
The CoPP commands are supported on the Dell Networking Z9000 platform.
control-plane-cpuqos
To manage control-plane traffic, enter control-plane mode and configure the switch.
Z9000
Syntax
control-plane-cpuqos
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
ip unknown-unicast
Enable IPv4 catch-all route.
Z9000
Syntax
ip unknown-unicast
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding
table in hardware which gets added as a default configuration after the initialization
of FIB Agent module, use the no ip unknown-unicast command.
Control Plane Policing (CoPP)
487